What Should I Pay Attention To During The Installation Of The Electric Ball Valve?

When installing Lined Ball Valve, there are two key installation points that need special attention and must not be ignored. Next, let's take a look at these two important points in the installation process of the electric ball valve.

When installing the electric ball valve, pay attention to one of the following points: the installation position, height, and inlet and outlet directions must meet the design requirements, ensure that the medium flow direction is consistent with the direction marked with the arrow on the valve body, and the connection must be firm and tight.

In addition, the installation of the electric ball valve also needs to pay attention to an important aspect: before installing the moving ball valve, an appearance inspection is required. For shut-off valves with a working pressure greater than 1.0MPa and used in main pipes, strength and strict performance tests must be carried out before installation. Only after passing the test can it be put into use.

When selecting a valve electric device, the operating torque is a more critical parameter. The movement of the electric ball valve can be achieved by monitoring the stroke, torque or axial thrust.

The efficiency and utilization of the valve electric device are affected by various factors, including the valve type, device specifications, and the specific location of the valve in the pipeline or equipment. Therefore, the electric ball valve device plays a vital role in realizing the valve program control, automatic control, and remote control functions. When choosing a suitable valve, follow these steps: first clarify the purpose of the valve in the equipment or device, and then determine the working conditions of the valve, such as applicable media, working pressure, working temperature, etc.

Please determine the nominal diameter and connection method of the valve connection pipe, including flange, thread, welding, etc.

The gate valve controls the flow by making a lateral movement of the disc-shaped gate on the circular valve seat mouth, and can only be better controlled when it is close to closing. Therefore, it is usually not used for flow regulation. Valves for reversing and diverting can have three or more channels as needed.

Plug valves and ball valves are more suitable for this purpose. However, in some cases, as long as two or more valves are properly connected together, most valves for reversing and diverting will choose one of these types of valves.